%20norskebacker_logo1.jpg){kind=logo}
INDUSTRY SECTORS WE SERVE TO
Thermostat and temperature limiter with manual reset
Tubular elements with Ø 8.5 mm can be supplied with fitted thermostat and temperature limiter with manual reset. These are fitted at the end of the electrical element. This element design with fitted BTS and BTC is approved by NEMKO, VDE and UL and is especially suitable for heating fluids.
To decide which cut-off temperature the temperature limiter should have, measurements must be taken under actual operating conditions. The cut-off temperature must be at least 25–30 °C higher than the maximum temperature of the temperature limiter during normal operation.
Technical data
Thermostat | Temperature limiter | ||
Type designation | BTS 085 060 (10) 130 |
| |
Cut-off temp. | 60 (10) 130°C |
| |
Tolerance | plus minus 5°K |
| |
Operation | plus minus 1°K |
| |
Max. voltage | 250 V |
| |
Max. current | 10 A |
| |
Contact resistance | < 20m Ω |
| |
Ambient temperature | T 180°C |
| |
Certificate | Nemko-certificate nr. 945010701 |
| |
Compliant with | EN 60730-2-9:1995 |
| |
Connection | Normal flat pin or cables spot welded to the connection bolt | ||
Advantages
- Does not take up space outside the tubular element
- Does not require extra cable connection
- Is ready fitted in the element
- Secure cut-off near the heat source
- Functions with low cost
Examples of use
- Dishwashers
- Washing machines
- Photographic developers
- Hot-water tanks
- Coffee makers
- Air heating with forced through-flow
Related products
-
Tubular element fitted with thermal fuse
Most tubular elements can be supplied with a thermal fuse fitted. This solution is especially suitable in connection with heating fluids. To decide which cut-off temperature the thermal fuse should ha... Read more >> -
Thermostat and temperature limiter with manual reset
Read more >>
NORSKE BACKER AS · JOSTEIN SVENHEIMS VEG 8-10 · NO-2212 KONGSVINGER · TEL. +4762828828
SALG/FORESPØRSEL: [email protected]NO · FAKTURAADRESSE: [email protected]